239
Chapter 4 Remote Interface Reference
Calibration Commands
4
Calibration Commands
For an overview of the calibration features of the function generator,
refer to “Calibration Overview” in chapter 3 starting on page 123.
For a detailed discussion of the function generator’s calibration
procedures, refer to chapter 4 in the Agilent 33250A Service Guide.
CALibration:SECure:STATe {OFF|ON},<code>
CALibration:SECure:STATe?
Unsecure or secure the instrument for calibration. The calibration code
may contain up to 12 characters. The :STAT? query returns “0” (OFF) or
“1” (ON).
CALibration:SETup <0|1|2|3|
. . .
|115>
CALibration:SETup?
Configure the function generator’s internal state for each of the
calibration steps to be performed. The :SET? query reads the calibration
setup number and returns a value from “0” to “115”.
CALibration:VALue <value>
CALibration:VALue?
Specify the value of the known calibration signal as outlined in the
calibration procedures in the Agilent 33250A Service Guide. Use the
CAL:SET command to configure the function generator’s internal state
for each of the calibration steps to be performed. The :VAL? query
returns a number in the form “+1.0000000000000E+01”.
CALibration?
Perform a calibration of the instrument using the specified calibration
value (CAL:VAL command). Before you can calibrate the function
generator, you must unsecure it by entering the correct security code.
Returns “0” (PASS) or “1” (FAIL).
To Next Page
Loading...
Need help?
General
