140
Chapter 4 Remote Interface Reference
SCPI Command Summary
4
Command Summary
(see page 223 for more information)
PHASe {<angle>|MINimum|MAXimum}
PHASe? [MINimum|MAXimum]
PHASe:REFerence
PHASe:UNLock:ERRor:STATe {OFF|ON}
PHASe:UNLock:ERRor:STATe?
UNIT:ANGLe {DEGree|RADian}
UNIT:ANGLe?
(see page 235 for more information)
*STB?
*SRE <
enable value>
*SRE?
STATus
:QUEStionable:CONDition?
:QUEStionable[:EVENt]?
:QUEStionable:ENABle <
enable value>
:QUEStionable:ENABle?
*ESR?
*ESE <
enable value>
*ESE?
*CLS
STATus:PRESet
*PSC {0|1}
*PSC?
*OPC
Phase-Lock Commands
Status Reporting Commands
Parameters shown in bold are selected following a *RST (reset) command.
To Next Page
Loading...
