Agilent Technologies 33250A

138
Chapter 4 Remote Interface Reference
SCPI Command Summary
4
Command Summary
(see page 195 for more information)
These commands are used for Sweep and Burst only.
TRIGger:SOURce {IMMediate|EXTernal|BUS}
TRIGger:SOURce?
TRIGger
*TRG
TRIGger:DELay {<
seconds>|MINimum|MAXimum} Triggered Burst Mode
TRIGger:DELay? [MINimum|MAXimum]
TRIGger:SLOPe {POSitive|NEGative} “Trig In” Connector
TRIGger:SLOPe?
BURSt:GATE:POLarity {NORMal|INVerted}
External Gated Burst
BURSt:GATE:POLarity?
OUTPut
:TRIGger:SLOPe {POSitive|NEGative} “Trig Out” Connector
:TRIGger:SLOPe?
:TRIGger {OFF|ON}
:TRIGger?
(see page 209 for more information)
*SAV {0|1|2|3|4} State 0 is the instrument state at power down.
*RCL {0|1|2|3|4} States 1 through 4 are user-defined states.
MEMory:STATe
:NAME {0|1|2|3|4} [,<
name>]
:NAME? {0|1|2|3|4}
:DELete {0|1|2|3|4}
:RECall:AUTO {OFF|ON}
:RECall:AUTO?
:VALid? {0|1|2|3|4}
MEMory:NSTates?
Triggering Commands
State Storage Commands
Parameters shown in bold are selected following a *RST (reset) command.