37
Chapter 2 Front-Panel Menu Operation
To Output an FSK Waveform
4
2
3 Set the “hop” frequency.
Press the Hop Freq softkey and then set the value to 500 Hz using the
numeric keypad or the knob and arrow keys.
4 Set the FSK “shift” rate.
Press the FSK Rate softkey and then set the value to 100 Hz using the
numeric keypad or the knob and arrow keys.
At this point, the function generator outputs an FSK waveform (if the
output is enabled).
5 View the waveform.
Press t
o view the waveform parameters.
To turn off the Graph Mode, press
again
.
To Next Page
Loading...
