Agilent Technologies 7000 Series User Manual

8 7000/7010 Series TQ GC/MS Operating Manual
Controlling CC Flow 104
Controlling JetClean Hydrogen Flow 104
Venting the MS 105
High Vacuum Pressure in EI Mode 106
To Set Monitors for MS Temperature and Vacuum
Status 107
To Set the MS Analyzer’s Temperatures 109
To Set the GC/MS Interface Temperature from
MassHunter 111
To Configure CC Gas 112
To Set the Mode for the Optional JetClean System 113
To Set the JetClean Parameters for the Clean Only
Mode 114
To Set the CC Gas Flow Rates 115
To Autotune the MS for EI Mode 117
To Open Left Side Panel for Access to the Analyzer
Chambers 119
To Pumpdown the MS 120
To Vent the MS 124
To Set the GC/MS Interface Temperature from the
7890 GC 126
To Save a Method on the 7890 GC 127
6 Operating in CI Mode
Setting Up Your MS to Operate in CI Mode 130
Operating the CI MS 131
Start the system in CI mode 131
High Vacuum Pressure in CI Mode 132

Agilent Technologies 7000 Series Specifications

General

Brand	Agilent Technologies
Model	7000 Series
Category	Industrial Equipment
Language	English