Install Cable Enclosures, Wall Boxes, and Branch Cables
8-12
SDC Standard System Distribution Cable
Maximum length per branch cable run: 152 meters (500 feet)
SDC Cable Diameter: 0.8 cm (0.34 inch) dia.
SDC Weight per 30.5 meters (100 feet): 2.9 kg (6.3 lbs)
SDC Spool Lengths: 152-meter (500-ft.) — part number 8120-3774
76-meter (250-ft.) — part number 8120-3775
30.5-meter (100-ft.) — part number 8120-3502
XSDC Extended System Distribution Cable
Maximum length per branch cable run: 304 meters (1000 feet)
XSDC Cable Diameter: 1.1 cm (0.44 inch)
XSDC Weight per 30.5 meters (100 feet): 4.2 kg (9.4 lbs)
XSDC Spool Size: 304-meter (1000-ft.) — part number 8120-3776
229-meter (750-ft.) — part number 8120-3777
Unshielded Twisted Pair Distribution Cable
UTP Orange Plenum Rated—UTP cable 1000' M3199AI-P01
SDC and XSDC Wall Box Connections
It is the customer’s responsibility to install standard NEMA switch wall
boxes at convenient locations that are within the length limits of the local
distribution cables (LDC). Minimum depth of the switch wall box must be
at least 7 cm (2 3/4 inches).
a. Pull the branch cable through the switch wall box so that there is at
least 20 cm (8 inches) of free cable to work on.
b. Strip off approximately 6.4 cm (2.5 inches) of insulation from the cable
end exposing the braided shield. Use care not to cut or damage the
braided shield.
c. Carefully, unravel the braided shield from the cable and separate the
drain wire. Cut off the first 5 cm (2 inches) of braided shield and fold
To Next Page
Loading...
Need help?
General
