258 Chapter 4
Instrument Functions: P - Z
System
Instrument Functions: P - Z
4.9.5.2 IP Address
Allows you to set the IP (internet protocol) address, domain name and node (host) name for
the instrument. The IP address of the instrument can be changed by entering a numeric
address composed of numbers and decimal points. Press
ENTER to complete the entry.
Key Path: System, Config I/O
State Saved: Survives Preset and power cycle, but not saved in Instrument State.
Factory
Default:
199.199.199.199 (Not reset by System, Restore Sys Defaults.)
Remote Command:
:SYSTem:COMMunicate:LAN[:SELF]:IP <string>
:SYSTem:COMMunicate:LAN[:SELF]:IP?
Example: SYST:COMM:LAN:IP “150.222.50.52 mypsa”
Sets the IP address to 150.222.50.52 and sets the host name to mypsa.
4.9.5.3 Host Name
Displays the host name of the instrument. Pressing the key activates the alpha editor,
which enables you to change the host name. (Press
ENTER to complete the entry.)
NOTE This will not change your LAN system representation of the host name. You
must work through your local system administrator to change the host name.
Changing it in the instrument only changes the displayed information, it will
not enable LAN access with the new name.
Key Path: System, Config I/O
State Saved: Survives Preset and power cycle, but not saved in Instrument State.
Factory
Default:
mypsa (Not reset by System, Restore Sys Defaults.)
Remote Command:
See above command :SYSTem:COMMunicate:LAN[:SELF]:IP <string>
Example: SYST:COMM:LAN:IP “150.222.50.52 mypsa”
Sets the IP address to 150.222.50.52 and sets the host name to mypsa.
To Next Page
Loading...
Need help?
General
