Agilent Technologies E4448A User Manual

Chapter 4 259
Instrument Functions: P - Z
System
Instrument Functions: P - Z
4.9.5.4 Host ID (Remote Command Only)
Enables you to query the host ID remotely. The current value of the host ID can be viewed
on the display by pressing
System, Show System.
SCPI Status Bits/
OPC Dependencies: None
Factory
Default: Value is unique to your instrument (Not reset by
System, Restore Sys
Defaults
.)
Remote Command:
:SYSTem:HID?
Remote Command Notes: The host ID cannot be set remotely, it can only be queried.
Example: SYST:HID?
4.9.5.5 Subnet Mask
Changes the subnet mask of the instrument. The subnet mask is a 32-bit address mask
used in IP networks to indicate the bits of an IP address that are used for the subnet
address. The default address is 255.255.0.0 for a class B network
Key Path: System, Config I/O
State Saved: Survives Preset and power cycle, but not saved in Instrument State.
Factory
Default:
255.255.0.0 (Not reset by System, Restore Sys Defaults.)
History: Added with firmware revision A.03.00.
Remote Command:
There is no equivalent remote command.
4.9.5.6 Gateway Address
Allows you to set the gateway address. The gateway address feature is used to manipulate
the gateway used to reach the destination. The gateway address can be changed by
entering a numeric address composed of numbers and decimal points. Press
ENTER to
complete the entry.
Key Path: System, Config I/O
State Saved: Survives Preset and power cycle, but not saved in Instrument State.
Factory
Default:
0.0.0.0 (Not reset by System, Restore Sys Defaults.)
History: Added with firmware revision A.03.00.

Agilent Technologies E4448A Specifications

General

Brand	Agilent Technologies
Model	E4448A
Category	Measuring Instruments
Language	English