Agilent Technologies, Inc.
2850 Centerville Road
Wilmington, DE 19808-1610
USA
© Agilent Technologies 2000
All Rights Reserved. Reproduction,
adaptation, or translation without
permission is prohibited, except as
allowed under the copyright laws.
Part number G1290-90317
First Edition, 3/2000
Replaces Part No. G1290-90310,
Operating and Service Manual, and part
No. G1883-90310, Operating and
Service Manual.
HP® is a registered trademark of
Hewlett-Packard Co.
Silcosteel® is a registered trademark of
Restek Corp.
Swagelok® is a registered trademark of
Swagelok company.
Printed in USA
Safety Information
The Agilent Technologies 7694
Headspace Sampler meets the following
IEC (International Electrotechnical
Commission) classifications: Safety
Class 1, Transient Overvoltage
Category II, and Pollution Degree 2.
This unit has been designed and tested in
accordance with recognized safety
standards and designed for use indoors.
If the instrument is used in a manner not
specified by the manufacturer, the
protection provided by the instrument
may be impaired. Whenever the safety
protection of the Agilent 7694 has been
compromised, disconnect the unit from
all power sources and secure the unit
against unintended operation.
Refer servicing to qualified service
personnel. Substituting parts or
performing any unauthorized
modification to the instrument may
result in a safety hazard. Disconnect the
AC power cord before removing covers.
The customer should not attempt to
replace the battery or fuses in this
instrument. The battery contained in this
instrument is recyclable.
Safety Symbols
Warnings in the manual or on the
instrument must be observed during all
phases of operation, service, and repair
of this instrument. Failure to comply
with these precautions violates safety
standards of design and the intended use
of the instrument. Agilent Technologies
assumes no liability for the customer’s
failure to comply with these
requirements.
WARNING
A warning calls attention to a condition
or possible situation that could cause
injury to the user.
CAUTION
A caution calls attention to a condition
or possible situation that could damage
or destroy the product or the user’s
work.
+ Indicates a hot surface
* Indicates earth (ground) terminal
Sound Emission Certification for
Federal Republic of Germany
Sound pressure Lp < 68 dB(A)
During normal operation
At the operator position
According to ISO 7779 (Type Test)
Schallemission
Schalldruckpegel LP < 68 dB(A)
Am Arbeitsplatz
Normaler Betrieb
Nach DIN 45635 T. 19 (Typprüfung)
To Next Page
Loading...
Need help?
General
