Index-10 Service Guide N5242-90001
Index
kits
calibration, 2-11, 3-7
handle
part numbers
, 6-83
rack mount
part numbers
, 6-83
upgrade
order numbers
, 6-83
part numbers
, 6-82
verification, 2-11, 3-7
knob
front panel
illustrated
, 6-11
part number
, 6-10
test
, 4-15
troubleshooting
, 4-13
L
LAN
connector
rear panel
, 5-33
cross-over cable
, 4-21
IP address, 4-19
ping command
, 4-19
ping to and from
, 4-18
subnet mask, 4-19
testing between analyzers
, 4-20
troubleshooting
, 4-18
LCD assembly
illustrated, 6-13
parts list
, 6-12
LED board
illustrated, 6-19, 6-25, 6-33,
6-41, 6-47, 6-59
part number
, 6-18, 6-24, 6-32,
6-40, 6-46, 6-58
LED board, front panel
illustrated, 6-73, 6-75
part number
, 6-72, 6-74
removal and replacement
illustrated
, 7-59
procedure
, 7-58
linearity
source power
test
, 3-29
test port output power
test
, 3-29
lithium battery
removal and replacement
illustrated
, 7-63
procedure
, 7-62
lithium battery disposal
, 1-8
LO synthesizer board
removal and replacement
procedure
, 7-14
troubleshooting
, 4-30
load match
cause of failure, 8-11
definition of
, 8-11
measurements affected by, 8-11
locating
assembly part numbers, 6-7
hardware part numbers
, 6-9
miscellaneous part numbers,
6-8, 6-9
replaceable part numbers
by reference designator
, 6-5
by type of part
, 6-7
M
machine screws
in bottom assemblies
illustrated, 6-73
part numbers
, 6-72
in external analyzer
illustrated
, 6-79
part numbers
, 6-78
in Option 029 bottom assemblies
illustrated
, 6-75
part numbers
, 6-74
in rear panel assembly
illustrated
, 6-81
part numbers
, 6-80
magnitude check
failure of, 3-16
test port cables, 3-15
maintenance
cleaning, 2-3
preventive
effect on error terms
, 8-3
max output power
and frequency range, 5-5
measurement
calibration, 8-4
traceability
, 3-21
path
, 3-21
uncertainty
, 3-20
measurement configuration
high dynamic range, 5-17
normal
, 5-17
measurement system
troubleshooting, 4-23
memory modules
part numbers, 6-82
midplane board
illustrated, 6-15
part number
, 6-14
removal and replacement
illustrated
, 7-19
procedure
, 7-18
miscellaneous parts
location of part numbers, 6-8,
6-9
required for servicing
, 2-12
miscellaneous replaceable parts
part numbers, 6-82
mixer brick
illustrated, 6-19, 6-25, 6-33,
6-41, 6-47, 6-59
operation
, 5-21
part number
, 6-18, 6-24, 6-32,
6-40, 6-46, 6-58
removal and replacement
illustrated
, 7-35
procedure, 7-34
troubleshooting
, 4-38
module
exchange
procedure
, 6-4
monitor, external
, 4-12
motherboard, system
illustrated, 6-15
operation
, 5-31
part number, 6-14
removal and replacement
illustrated
, 7-17
procedure, 7-16
motherboard, test set
illustrated, 6-19, 6-25, 6-33,
6-41, 6-47, 6-59
part number, 6-18, 6-24, 6-32,
6-40, 6-46, 6-58
N
N1966A, pulse I/O adapter
, 2-9
N4689A, USB hub
, 2-9
nameplate
front panel
illustrated, 6-11
part number
, 6-10
network analyzer,
See analyzer
noise downconverter
illustrated, 6-25, 6-33, 6-47,
6-59
operation
, 5-27
part number
, 6-24, 6-32, 6-46,
6-58
removal and replacement
illustrated
, 7-55
procedure
, 7-54
noise figure measurement
capability, Option 029
, 2-4
noise floor, test
, 3-32
noise measurement group
block diagram, 5-28
functional description of
, 5-6
operation, 5-27
noise meeasurement group
defined, 4-27
noise receiver board
operation, 5-27
noise, trace noise test
, 3-30
To Next Page
Loading...
