Agria 3400 - Page 20

20 agria Two-Wheel Tractor 3400; 3400 KL
Hoeing Attachment
When hoeing and tilling on difficult
ground (stony, hard etc.) the machine
may give sudden jerking movements in
an upward and forward direction and
therefore extra care should be taken
under these conditions.
Adjust protective cover of hoeing attach-
ment so that only those parts of tools
which penetrate the soil are not covered.
When hoeing, make sure depth bar is
adjusted properly.
Mowing Implement
Handle with care! Sharp blades of the
cutter bar may cause injuries! Remove
knife guards only for mowing and refit
immediately after work has finished.
For transport and storage always mount
the knife guards. Secure finger bars
additionally with tension springs.
Do not transport the dismounted cutter
bar without knife guards.
When mounting and dismounting the
cutter bar, make sure all blades are pro-
tected by the knife guards.
To exchange the knife and to mount/dis-
mount the knife driver, make sure that
you turn screws away from cutting
blades.
For grinding the mowing knives, always
wear safety goggles and gloves.
Trailer
Make sure to not exceed permissible
tongue load of trailer hitch, floating draw-
bar or hitch.
When coupling the drawbar, make sure
manoeuvrability at coupling point is suf-
ficient.
Do not exceed gross axle weight rating,
towing capacity and gross weights.
Before driving, check brake function and
rear lighting for proper operation.
Regularly check brake systems closely.
Have adjustments and repairs on the
brake system carried out by a profes-
sional workshop or an authorized brake
service station only.
When driving with mounted trailer, do
not use single-wheel braking.
On tractors equipped with single-wheel
transmission do not engage single-
wheel transmission. Single-wheel trans-
mission must be locked!
For tractors equipped with differential
lock; do not use differential lock when
driving in curves.
Only one passenger may ride on the
trailer, provided a safe passenger seat
is available.
No additional passengers may be car-
ried.
When driving downhill, shift into lower
gears in time. On slopes never de-clutch
to change gears.
Weights
Fit weights properly and at specified
points.
1. Safety Instructions
1