Agria 3400 - Safety Circuit

32 agria Two-Wheel Tractor 3400; 3400 KL
Safety circuit
The two-wheel tractor is fitted with a safety circuit.
 Stop setting: Clutch is not engaged when safety
circuit lever (4) is not operated, but the engine continu-
es to run.
 Operation setting: to operate press the safety
circuit lever (4) down; this creates a power con-
nection between the engine and gearbox through
the solenoid clutch.
l The safety switch must be operated in two sta-
ges:
1. Press the safety lever (4) in downwards.
2. Operate press switch (3)
When the drive to the wheels and power-
take-off shaft is switched on, the wheels
and the tools begin to turn immediately,
therefore do not press the safety circuit lever
down until the drives are at 0.
W
Do not fasten safety circuit lever!
Clutch
The machine is fitted with a solenoid clutch and is
activated on using a switch which is located in the
clutch lever. So that the clutch can be engaged
smoothly a soft start module is arranged ahead
of this.
The clutch lever (5) is intended to be used for
pausing during operation, to carry out gear chan-
ges and power-take-off shaft changes.
When the clutch lever is pulled up to the setting
"0" the clutch is disengaged, i.e. the engine is no
longer driving the machine.
3. Devices and Operating Elements


4
1.
2.
5
3
I
The soft start module is fitted with overheating protection. When the clutch
is operated several times the soft start module can overheat and switch off;
the clutch can no longer be engaged.
- Wait until the soft start module has cooled down again.

3