Agria 3400 - Maintenance

78 agria Two-Wheel Tractor 3400; 3400 KL
5. Maintenance
General Maintenance
 Every time you take up operation watch out
for fuel and oil leakage, repair if necessary.
 Regularly check bolts and nuts for tight fit,
re-tighten, if necessary.
 At least once a year and after cleaning:
Slightly grease all gliding and moving parts (e.g.
speed control lever, lever bearing, etc.) with bio-
lubricating grease and bio-lubrication oil.
Cleaning
Engine
Clean engine only with a cloth. Avoid spraying
with air-compressed water jets, as water might
leak into ignition and fuel system causing
malfunctions.
Machine
After each operation immediately clean the
tilling tools and the protective hood. Therefore
dismount the protective hood. Grease all
gliding parts with Bio-ubricating grease and Bio-
slushing oil.
After each cleaning with air-compressed water
jets lubricate all lubrication points, oil and let
two-wheel tractor run for a short time to press
water out.
Apply grease generously to leave a grease ring
around bearings to prevent water, plant sap,
and dirt from penetrating.
Graphic Symbols
Worn and missing stickers with operating and
safety instructions must be replaced.



èI
5