Agria 5400 - Starting 2-Stroke Petrol Engine

36 Power Mower 5400 Edition 02.97
4. Commissioning and Operation
Starting
2-Stroke Petrol Engine
l Open both fuel taps (G/14)
l Engine cold:
Swivel Choke lever (F/8) to position " ".
l Press tickler (G/2 or H/7) on
carburetor until fuel overflows.
l Engine warm: Leave Choke knob in
original position (operation position)
l Move engine-off-switch (B/1) to op-
erating position “I”.
l Move speed control lever (B/9) to
approx. 1/3 – 1/2 throttle.
l Pull clutch hand lever (B/3) and lock
with pawl (B/4) (start position).
l Pull starting-cord on handle (G/15)
until you feel starter clutch engage. Then
pull hard and fast to start the engine.
After the start, let cord glide back. Do
not let snap.
l Once the engine has started, slowly
move speed control lever to centre po-
sition and let engine warm up for some
time.
l Move Choke slowly back to operat-
ing position (if it was actuated).