Edition 02.97 Power Mower 5400 39
4. Commissioning and Operation
After commissioning the machine and
after changing knives, re-tighten all
screws and nuts on mowing drive and
cutter bar after approx. 15–30 operat-
ing minutes and subsequently after
every 4 operating hours (especially
cutter bar attachment bolts and screws
on knife driver and mowing drive cou-
pling).
Starting the Engine on Slopes
If the engine comes to a halt during op-
eration and re-start becomes necessary,
proceed as follows:
l
Leave mowing drive and wheel drive
switched on. The drives act like brakes.
l
Engage hand brake (if available).
l
Pull clutch hand lever and lock pawl.
l
Move safety switch to operating po-
sition.
l
Re-start engine.
Mowing on flat areas Mowing on slopes
To Next Page
Loading...
