The cooling air for the E-box is cleaned by a wire mesh filter
on the right-hand side. The cooling capacity is reduced if the
wire mesh filter is soiled.
Always keep the wire filter mesh and the wire mesh filter free
from mowing residues and dirt.
Clean the wire mesh filter before each start-up.
Open the green service flap (A/24).
Undo the wing nut (1) on the filter cover of the air filter box
(A/21) and remove the filter cover. Clean the wire mesh filter
by blowing out or with water.
Re-insert the fire mesh filter after cleaning and close the filter
cover.
Close the green service flap. Pay attention that the service flap
is firmly seated in the rubber ball cups.
Checking the oil level
You can check the fill level (1) of the hydraulic oil on the right-
hand side of the machine, see (A/33).
Check the oil level every 25 operating hours.
When exchanging the mounted implement, some hydraulic oil
may remain inside the mounted implement. Check the oil level
more often when the mounted implements are frequently ex-
changed to ensure that there is always enough liquid in the
reservoir.
To Next Page
Loading...