3.5 Display on the remote control
Menu page 1 Machine specifications
The following machine data and states are shown on the display:
(1) Travel speed
(2) Residual charge of the battery
(3) Remaining run time
(4) Hours of operation
(5) Power reduction PTO (power take off shaft drive)
(6) Power reduction in Watt
(7) Residual charge of the battery in the remote control
(8) Direction of rotation PTO shaft with display on/off
(9) Set target speed of the PTO shaft
(10) Floating position
(11) Signal strength of the radio remote control
To Next Page
Loading...