Move the machine to the working area and stop with the
mounted implement over a clear space.
Use the joystick (B/1) to adjust the travel speed of the machine
and steer it.
From the perspective of the operator standing behind the ma-
chine in the direction of travel, slowly move the joystick:
- up = forward
- down = reverse
- to the left = left, - to the right = right.
The machine's speed depends on the position of the joy-
stick (B/1) and the travel speed selector switch (B/3).
Use the joystick on the remote control carefully and avoid
sudden changes of direction.
Observe the pre-set direction of travel.
Move the machine slowly, so that you can become familiar
with the machine and check that the commands are executed
correctly. Note that the direction commands must be executed
in reverse when driving backwards.
Avoid driving downhill for longer periods when the rechargea-
ble battery is fully charged. Recuperation can create a high
load on the batteries; the machine switches off for component
protection reasons.
Select the travel speed range with the travel speed selector
switch (B/3). Work in position 1 to 3 depending on the load of
the mounted implement. Use position 4 only for driving when
the mounted implement is not switched on. You can adjust the
speed ranges, see page 18.
The machine can be turned on the spot (zero-turn).
The zero turn is only possible if you specify a direction and the
speed simultaneously with the joystick (B/1).
To do so, move the joystick (B/1) all the way to the right or left
and somewhat up or down.
To Next Page
Loading...