3.6 Installing and removing implements
Prior to attaching and starting the mounted implement, read and observe the operating instructions
of the mounted implement.
Attachment:
• The contact surfaces of machine and mounted implement must be clean.
• Leave the machine switched on.
• Make sure that the machine’s PTO shaft is switched off.
• Ensure that the mounted implement to be attached has a secure stand.
• Make sure you keep at a distance to the machine while the lower link is moving. These is a risk of
bruising.
(1) Move the lower link to the bottommost position.
(2) Open the catch hooks. The catch hooks must be able to receive the bottom coupling points of the
mounted implement’s three-point mounting bracket.
(3) Lift the lower link until the balls are seated in the catch hooks and the safety catches are locked in
closed position.
(4) Set the correct link of the upper link to be able to attach your mounted implement.
(5) Connect mounted implement and upper link.
Connect the drive shaft. Observe the operating instructions of the drive shaft manufacturer.
Note the speed and sense of rotation specified by the manufacturer when starting the mounted implement.
The mounted implement is now ready for use.
To Next Page
Loading...