to the machine so that you can safely monitor, con-
trol and influence it at all times.
Remove any plugging on the machine after the im-
plement has come to a standstill and with switched
off remote control. Do not use your hands under any
circumstances, but use a stick or a suitable tool in-
stead.
If the machine encounters a foreign object, switch
off the machine and remote control and wait for the
mounted implement to come to a standstill. Check
the machine for any damage and repair it before
you switch on the implement again.
Always keep the implement in a clean, well-kept
and properly maintained condition. This will main-
tain its efficiency and ensure safe operation. Keep
the remote control clean and dry and avoid oil and
grease residues.
Keep the safety signs and instruction manual in
good condition; exchange or replace them if neces-
sary.
Operation on slopes
Do not work on slopes where the implement could
slip or tip over. This could cause serious damage to
the implement or other objects and injuries to by-
standers.
Work across the slope along the contour line and in
an upwards direction when turning, if possible.
Watch out for holes, furrows, elevations and other
objects, to prevent slipping or tipping over.
Bear in mind that high grass can conceal obstacles,
hazards and small animals.
Avoid working on wet ground in steep terrain. Spe-
cial care should be taken in the area of ditches and
river banks.
Additional safety instructions for children and
animals
Children can easily mistake this implement for a toy.
Therefore, never leave the machine or the remote
control unattended.
Bear in mind that children and animals may appear
in places where you don't expect them. Be particu-
larly careful when approaching areas that are not
open to view, bushes, trees or other objects, which
could obstruct your view of children or animals.
Finishing work
Never leave the machine unattended as long as the
machine is ready for operation.
Press both emergency stop switches - on the re-
mote control and on the machine - when leaving the
machine.
Take care not to park the hot machine in the blazing
sun.
To protect against unauthorized use, remove the
keys from the remote control and protect the ma-
chine against rolling away.
Implements
Attach an implement only when engine and imple-
ment drive are switched off.
Prior to attaching and starting the implement, read
and observe the operating instructions of the imple-
ment.
Use adequate tools and wear gloves to replace im-
plements and parts thereof.
Put the supporting equipment to the proper position
and ensure stability when you attach or remove an
implement.
Secure machine and implements against rolling
away (parking brake - if installed, wheel chocks).
There is a risk of injuries when you attach an imple-
ment. Take special care.
Attach an implement in accordance with the regula-
tions and only at the specified fixtures.
Always switch off the working tools during a
transport ride or when you drive to adjacent working
areas.
Secure machine and implement against unauthor-
ized use and rolling away when you leave it. If nec-
essary, install transport or safety equipment, and
put it in protective position.
Maintenance
Only trained specialist personnel, who can carry out
professional maintenance and repair, may carry out
this work.
Do not carry out maintenance and cleaning work
with the mounted implement running.
Protective devices and tools that are subject to
wear and tear must be regularly inspected and re-
placed if necessary!
Do not carry out repairs such as welding, grinding
or sharpening, drilling etc. on structural, safety-rel-
evant parts!
Disconnect the battery before commencing welding
work.
During welding work, make sure that the electrical
and electronic components of the machines are not
influenced.
Keep the machine and attachments clean, to avoid
the risk of fire.
Regularly check nuts and bolts for tightness and re-
tighten if necessary.
To Next Page
Loading...