SmartyCam
User Manual
Release 1.04
12
www.smartycam.com
5
Chapter 5 – SmartyCam configuration
In order to configure SmartyCam data overlay (selection of data to visualize, their layout
and position) SmartyManager software – expressly developed by AIM – needs to be
used.
This software is provided with a CD included in SmartyCam kits and can be downloaded
from www.smartycam.com, download area.
To configure SmartyCam connect it to the PC:
WARNING: it is strictly necessary to install SmartyManager software before
SmartyCam connection to the PC
(v. SmartyManager user manual downloadable from www.smartycam.com)
• set the preferred data overlay;
• transmit the new configuration to SmartyCam;
• switch the camera off and on again
• SmartyCam will automatically set that configuration.
Refer to SmartyManager user manual for information about data overlay
configuration.
SmartyCam slave needs its master (AIM logger or ECU Bridge) configuration through
Race Studio 2 software, included in both the slave kits with 2m and 4m power cable).
Please note: SmartyCam configuration is independent from its master
configuration: it is thereby unnecessary to modify it changing SmartyCam master.
To Next Page
Loading...
