Aim Smartycam - Introduction

SmartyCam
User Manual
Release 1.04
4
www.smartycam.com
0
INTRODUCTION
SmartyCam features three different working modes.
Stand alone: for non-motorsport applications or for motorsport applications whenever
there is no Engine Control Unit (ECU) nor AIM data acquisition system (from here onward:
logger).
Slave connected to the vehicle ECU: for motorsport applications to sample data out
coming from the ECU without possibility (or need) to sample data coming from additional
sensors. In this case an ECU Bridge is required.
Slave connected to an AIM logger: for motorsport applications in case a detailed
analysis of performances is needed, using also additional sensors. In this case the ECU
bridge is not required because connection to the vehicle ECU is made using an AIM
logger.