Airo XP Series - Platform Access; Standard Access with Gate (XP4 E - XP5 E - XLP5 E); Standard Access with Gravity Rod (XP4 E DUAL - XP5 E DUAL - XLP5 E DUAL)

Use and Maintenance Manual - XP - XLP Series
Page 27
5.3 Platform access
The “access position” is the only one from which loading or unloading of persons and materials is allowed. The “access position” to
the work platform is the completely lowered configuration.
5.3.1 Standard access with gate (XP4 E - XP5 E - XLP5 E)
To get on the platform:
- Go up the ladder hanging on to the uprights of the entry
rails.
- Lift the locking detent.
- Open the gate and get onto the platform.
Check that, once you are on the platform, the gate has closed
again. Fasten the safety harness to the provided hooks.
FIG.10
5.3.2 Standard access with gravity rod (XP4 E DUAL - XP5 E DUAL - XLP5 E DUAL)
To get on the platform:
- Go up the ladder hanging on to the uprights of the entry
rails.
- Raise the entrance bar and get on board.
Check that, once you are on the platform, the bar falls down
closing the access. Fasten the safety harness to the provided
hooks.
FIG.11