Airo XP Series - Machine Cleaning; General Maintenance

Use and Maintenance Manual - XP - XLP Series
Page 40
7.2 Machine cleaning
To clean the machine use non-pressurized water jets after properly protecting the following parts:
- The control panel (both platform and ground)
- All electric boxes and electric devices in general.
- The electric motors.
Do not use pressurized water jets (high-pressure cleaners) to clean the machine.
After washing the machine, always:
- Dry the machine.
- Check integrity of plates and stickers.
- Lubricate the articulated joints equipped with greaser and the sliding ways.
7.3 General maintenance
Below are listed the main maintenance jobs to be done and the relevant schedule (the machine features an hour meter).
Operation
Frequency
Screw tightening (paragraph "Various adjustments”)
After the first 10 working hours
Oil level check in hydraulic tank
After the first 10 working hours
State of the battery (charging cleaning)
Every day
Deformation of tubes and cables
Every month
Stickers and code plates
Every month
Articulated joints greasing
Every month
Oil level check in hydraulic tank
Every month
Emergency devices efficiency check
Every year
Electric connections check
Every year
Hydraulic connections check
Every year
Periodic operation check and structure visual check
Every year
Screw tightening (paragraph "Various adjustments”)
Every year
Inclinometer operation check
Every year
Calibration check of pressure relief valve
Every year
Pedal braking system efficiency check
Every year
Automatic braking system efficiency check
Every year
M1 microswitch operation check
Every year
Total oil change in hydraulic tank
Every two years
Hydraulic filter replacement
Every two years
IT IS NECESSARY
TO SEND THE MACHINE TO THE MANUFACTURER FOR A COMPLETE CHECK
FOR A COMPLETE CHECK.