Airo XP Series - Braking System Adjustment and Operation Check; Pedal Brakes

Use and Maintenance Manual - XP - XLP Series
Page 48
7.3.6 Braking system adjustment and operation check
The machines, XP-XLP series, are equipped with a dual brake system for machine parking:
- Pedal braking system on rear pivoting wheels.
- Automatic brake system on the front fixed wheels.
The operation of both braking systems must be checked at least once a year.
7.3.6.1 Pedal brakes
The voluntary actuation of these brakes is for keeping the
machine in parking position and before lifting the work platform.
To check the operation of the pedal braking system:
 With platform completely lowered place the machine on a
flat ground, apply both brakes by acting on lever A.
 In this condition (both brakes applied), moving the machine
by pushing on handles B must not be possible.
 If the machine is not locked or if you note that, by pushing
on the handles, the machine tends to move from its position
it is necessary to replace one or both wheel supports with
brake.
 To unlock the pedal brakes, act on lever C.
Replace the wheel supports with brake using only original
accessories available at our Technical Support.
FIG.28
A
B
C