MPC2500 Operator’s Manual rev 1.0
102
Chapter 15: Effect
Copying the effect set
01. In the Eff field of the SELECT page, press the [WIN-
DOW] key.
The Effect Set window will be displayed.
02. In the Effect Set window, press the [F5] (COPY) key.
The Copy Effect Set window will be displayed.
03. In the Eff field (up), select the source effect set.
04.
In the Eff field (down), select the destination effect set.
05. Press the [F3] (DO IT) key.
The effect set selected in the Eff field (up) will be
copied to the effect set selected in the Eff field
(down). Pressing the [F4] (CANCEL) key cancels
the operation and closes the window.
Resetting the effect set
You can reset the setting for the effect set to the default
settings.
01. In the Eff field of the SELECT page, press the [WIN-
DOW] key.
The Effect Set window will be displayed.
02.
In the Effect Set window, press the [F2] (RESET) key.
The Reset Effect Setting window will be displayed.
03. In the Eff field, select the effect set you wish to reset.
04. Press the [F5] (DO IT) key.
The settings of the effect set selected in the Eff field
will be reset to the default settings. Pressing the [F4]
(CANCEL) key cancels the operation and closes the
window.
Shortcut between MIXER
and Efect mode
You can move from EFFECT mode to MIXER mode with
the functional key.
While in MIXER mode, you can easily switch to EF-
FECT mode by using the [F6] (GO2FX) key.
While in EFFECT mode, you can easily switch to
MIXER mode by using the [F5] (GO2MIX) key.
The following menus are available in MIXER/EFFECT mode:
MIXER mode EFFECT mode
L / PAN page MASTER page
L / OUT page MASTER page
FXSEND page FX page which is selected
in FX field.
SETUP page MASTER page
INPUT page MASTER page
Tips : This is especially useful when searching for the right effect
for the right sample.
To Next Page
Loading...
Need help?
General
