MPC2500 Operator’s Manual rev 1.0
71
Dividing a sample into regions of equal length (EQUALLY)
01. In the Sample field within the TRIM page, select a sample you wish to edit.
You can set the sample range you wish to edit by adjusting the start/ end point.
For more information about adjusting the start/end point, see “Adjusting the start point” and “Adjusting the end
point” section on page 63..
02. Press the [F5] (CHOP) key.
The ChopShop window will be displayed.
03. In the Mode field, select “EQUALLY”.
Number of Region: You set the number of regions you wish to divide the sample into.
04. Press the [F5] (DO IT).
The MPC2500 will start dividing the sample, and then go to the “ChopShop” page.
The next step is to adjust the divided regions.
Go to the “Adjusting the start/ end point of the region” section for more information.
The MPC2500 will divide a sample into seperate regions of equal length. You choose the number of sections.
To Next Page
Loading...
