MPC2500 Operator’s Manual rev 1.0
70
Chapter 12: Editing a sample
Dividing a sample by detecting the attack part of the phrase (AUTO)
01. In the Sample field within the TRIM page, select the sample you wish to edit.
You can set the sample range of your edit by adjusting the start/end points.
For more information about adjusting the start/end points, see “Adjusting the start point” and “Adjusting the end
point” section on page 63..
02. Press the [F5] (CHOP) key.
The ChopShop window will be displayed.
03. In the Mode field, select “AUTO”.
Recovery time ( 0 – 100) :
This sets the minimum time between the attack and the next attack. If you set this time too long, continuous
attacks may not be detected. Select a smaller value when the sample has a lot of attack parts.
Threshold ( 0 –100) :
This sets the detectable level of an attack. The smaller the value, the more sensitive the detection will be, so if
you select a very low value, everything will 'register' as an attack..
Sensitivity (0 – 100) :
This sets the sensitivity used while detecting an attack. Selecting a smaller value will make the detecting
process more sensitive towards varying attack levels.
04. Press the [F5] (DO IT).
The MPC2500 will start dividing the sample, then go to the “ChopShop” page.
The next step is to adjust the divided regions.
Go to the “Adjusting the start/ end point of the region” section for more information.
The MPC2500 divides a sample into several regions by automatically detecting the attack part of the phrase.
To Next Page
Loading...
Need help?
General
