MPC2500 Operator’s Manual rev 1.0
29
Selecting the editing region by bar
You can edit the sequence by bar. This is done in the BARS
page in the SEQ EDIT mode, which can be accessed by press-
ing the [MODE] key and then the [PAD 13].
Copying bars (COPY)
You can copy bars within the selected region to another
place. The length of the destination sequence will be
extended to add the copied bars.
01. Select the Edit field in the BARS page of the SEQ
EDIT mode, and select COPY.
The various fields necessary for copying will be displayed.
02. In the From sq field, select the source sequence.
03. In the To sq, select the destination sequence.
Tips: In the EVENTS page, the From sq, Tr field and the To sq, Tr
field only display the sequence number and the track number re-
spectively, but pressing the [WINDOW] key when the cursor is
in the From sq,Tr or To sq,Tr field, will bring up the Select win-
dow, where you can browse the sequence or track name to select.
04.
In the First bar field, select the first bar of the source sequence.
05.
In the Last bar field, select the last bar of the source sequence.
06. In the After bar field, select the destination.
The selected bars will be copied to the end of the
bar set here.
07. In the Copies field, select the number of times to
copy the data.
To copy the same phrase repeatedly, enter the num-
ber of copies in the Copies filed. You can copy it
repeatedly with one operation.
08. Press the [F6] (DO IT) key.
The MPC2500 will start copying the bars.
05. In the Value field, set the value to be adjusted.
You can set the Value between 0 and 9999. When
you select “MULTI VAL%” in the Mode field, you
can set the Value between 0 and 200.
06. Press the F6 (DO IT) key
The MPC2500 will start processing your changes.
To Next Page
Loading...
Need help?
General
