Alba MC250 - Requirements for the Electrical Connection; Erection of the Hoist; Placement of the Base Machine

MC250 page 12 of 78
MC250 Rev.02-USA  (+34) 944 71 16 00  (+34) 944 53 17 54  export@alba.es www.alba.es
2.4. Requirements for the electrical connection
 Supply point 208V 60Hz, with thermal protection 16A and differential protection of
300mA.
 Cable3x2,5mm
2
connecteddirecttosupplypoint,withmax.lenghtof30m(98ft5,1
in),withnoothersmachinesconnected,toavoidvoltagefaultor losses of power in
motor.
2.5. Erection of the hoist
2.5.1 Placementofthebasemachine
Payspecialattentionwhenmovingthe MC250forpositioningon thescaffolding.TheMC250
hasafrontlegtogivestabilitytotheassembly:











Placethehoistattheinstallationsite:
