Albatron PM266A PRO - Apic Mode; Mps Version Control for os

PM266A PRO/ PM266A
26
APIC Mode
By enabling this option, “MPS version control for OS” can be configured.
Options: Disabled、Enabled (default)
MPS Version Control For OS
sion that supports 8 more IRQs in the Windows NT environment.
S Select For DRAM > 64MB
operating system with greater than 64 MB of RAM.
DD S.M.A.R.T. Capability
logy is a technology that enables a PC to attempt to
t Features
e Control settings.
ng using the manual configuration.
SPD
RAM CAS Latency
When synchronous DRAM is installed, the number of clock
You can set the time to precharge. Options: 3T (default)、2T
The 1.1 version is the older ver
Choose the new 1.4 version for Windows 2000 and Windows XP.
Options: 1.4 (default)、1.1
O
Select “OS2” only if you are running the OS/2
Options: Non-OS2 (default)、OS2
H
Self Monitoring Analysis and Reporting Techno
predict the possible failure of storage drives. Options: Disabled (default)、Enabled
Small LOGO (EPA) Show
This item allows you to show or hide the small LOGO EPA.
Options: Disabled (default)、Enabled
Advanced Chipse
DRAM Clock/ Drive Control
Press <Enter> to enter next page for DRAM Clock/ Driv
DRAM Timing
This item determines DRAM clock/ timi
Options: Manual、By (default)
D
This item determines CAS Latency.
cycles of CAS latency depends on the DRAM timing. Do not reset this field from default value
specified by the system designer. Options:2 (default)、2.5
Precharge to Active (Trp)