Albatron PM266A PRO - Ur2 Duplex Mode; Onboard Parallel Port; Parallel Port Mode; Epp Mode Select

PM266A PRO/ PM266A
34
UR2 Duplex Mode
in only one direction at a time.
Mode Select” is set to “ASKIR” or “IrDA”.
ptions: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled
board parallel port.
ptions: ECP(default) Extended Capabilities Port.
l Port.
CP Mode Use DMA
Options: 3 (default)、1
s: 201 (default)、209、Disabled
ault)、300、290、Disabled
Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission
This field only configurable if “UART
Onboard Parallel Port
This item allows you to determine the parallel port interrupt and address.
O
Parallel Port Mode
This option allows you to select an operating mode for the on
O
EPP Enhanced Paralle
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode.
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9. Options: EPP 1.7、EPP1.9 (default)
E
Select a DMA Channel for the port.
Game Port Address
Game Port I/O Address. Option
Midi Port Address
Midi Port Base I/O Address. Options: 330 (def
Midi Port IRQ
This determines the IRQ that Midi Port will use. Options: 5 (default)、7