PM266A PRO/ PM266A
VIA VT6103 LAN Controller on board:
z 1/10/100 MHz full and half duplex operation
z Independent 2K byte FIFOs for receive and transmit
z Magic packet and wake-on-address filtering
z Software controllable power down
I/O facilities:
z One multi-mode Parallel Port capable of supporting the following specifications:
1. Standard & Bi-direction Parallel Port
2. Enhanced Parallel Port (EPP)
3. Extended Capabilities Port (ECP)
z Supports two serial ports, 16550 UART (one on back panel and one on front panel)
z Supports Infrared Data Transmission using IrDA
z Supports one VGA port
z Supports PS/2 mouse and PS/2 keyboard
z Supports 360 KB, 720 KB, 1.2 MB, 1.44 MB, and 2.88 MB floppy disk drives
z MIDI compatible
z Game port compatible
IDE Facilities:
z Supports Ultra ATA 66/ 100/ 133, DMA and PIO modes
z Supports IDE interface with CD-ROM
z Supports high capacity hard disk drives
z Supports installation of up to 4 drives, with separate IDE connections for Primary and
Secondary connectors
Watch Dog Timer:
z This mainboard contains a special feature called the “Watch Dog Timer” which is used to
detect when the system is unable to handle over-clocking configurations during the POST
stage. Once a problem is detected the system will reset the configurations and reboot the
system after five seconds.
4
To Next Page
Loading...
