PM266A PRO/ PM266A
29
P
P
When set to “YES”, BIOS will only initialize the PnP cards used for the boot sequence (VGA, IDE,
initialized by the PnP operating system like Windows® 95. When
t
O
S ystem Configuration Data (ESCD) if you have installed a
new add-on card and the system reconfiguration has caused such a serious conflict that the OS cannot
nabled
Resources Controlled By
the boot and Plug and Play compatible devices. If you choose
base address fields, since
、Manual
ing on
This is only configurable when “Resources Controlled By” is
t to “Manual”.
assigned to: PCI device
P
patible take the output from a VGA controller and
provide boot information and VGA compatibility.
O
mer (CLK)
PCI IRQ Assignment
This item allows you to select an IRQ address for your PCI slot 1-3.
nP/PCI Configurations
NP OS Installed
SCSI). The rest of the cards will be
set to “NO”, BIOS will initialize all the PnP cards. For non-PnP operating systems (DOS, Netware),
his option must be set to “NO”.
ptions: No (default)、Yes
Reset Configuration Data
elect “Enabled” to reset the Extended S
boot. Options: Disabled (default)、E
BIOS can automatically configure all
Auto, you will not be able to manually assign IRQ DMA and memory
BIOS automatically assigns them. Options: Auto <ESCD> (default)
IRQ Resources
When resources are controlled manuall
the type of device using the interrupt.
y, you can assign each system interrupt a type, depend
se
IRQ-3/4/5/7/9/10/11/12/14/15
CI / VGA Palette Snoop
Some graphic controllers that are not VGA com
map it to their display as a way to
ptions: Disabled (default)、Enabled
PCI Latency Ti
This item allows you to set up the PCI Latency Time (0-255). If you select the “32” it will optimize
PCI speeds. Options: 0-255、32 (default)
To Next Page
Loading...
