7.11.2 Set accessory type for each connector
• Select the settings icon from the phone menu (see the navigation section of your phone
model).
• Phone Audio
• Use one of the following:
o USB:
Select the type of device connected to the USB: Headset / Handsfree / Loudspeaker
o Jack:
Select the type of device plugged into the jack: Headset / Handsfree / Loudspeaker
o Bluetooth (compatible Bluetooth® deskphone):
Select the type of device paired with your phone: Headset / Handsfree / Loudspeaker
•
7.11.3 Default device
If you have connected the same type of accessory in the jack and the USB connectors, you can define
which device will be used by default.
• Select the settings icon from the phone menu (see the navigation section of your phone
model).
• Phone Audio
• Accessory type
• Select the default connector (then the accessory) to be used: None / Jack / USB / Bluetooth
(compatible Bluetooth® deskphone).
Installing a Bluetooth® device
This feature is only available with compatible Bluetooth® deskphone. Otherwise the corresponding menu
is not displayed or is inactive.
Before performing the pairing operation, the device must be in detectable mode. Consult the user
documentation of your Bluetooth® device.
• Using the left-right navigator keys, select the settings menu.
• Phone Bluetooth Add device.
Scanning starts.
• Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed.
• Select the relevant device by pressing the associated key.
• Add the device by pressing on the associated key: Add device.
• Enter the PIN code of the device if necessary.
To Next Page
Loading...
