communications and timing cable and see if the link comes back up.
CONTEQPT
CONTEQPT (Card Failure - Device)
The CONTEQPT condition indicates a fault on the Equipment Controller that has caused
the system to declare a hardware failure. This condition may be declared due to a failure
in the SEEP or other unknown hardware failures. This is a major non-service affecting
alarm for the Equipment Controller and causes a redundancy switch to the mate.
Severity Major
Service affecting? No
Applicability Equipment Controller, FLC
Corrective Action
NOTICE
Service-disruption hazard
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure “Reseating a Card” (p. 3-19).
If
there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
Perform a warm reset of the card.
CLI config card card type shelf slot reset warm
WEBUI Select the card, click the Reboot tab, select Warm Reboot >Submit.
...................................................................................................................................................................................................
2
Perform a cold reset of the card.
Trouble-clearing procedures
CONTCOM
CONTCOM (Inter-shelf loss of communication)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-54
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................