EasyManua.ls Logo

Alcatel-Lucent 1830 PSS-16 - Page 460

Alcatel-Lucent 1830 PSS-16
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
...................................................................................................................................................................................................
2
Set the value if necessary.
CLI config interface
shelf/slot/port
wavekey in | out
frequency
power value
WEBUI If the Expected Power field is set to Off, select On and click Set Power.
...................................................................................................................................................................................................
3
Perform the procedure “Path Power Trace” (p. 3-8) to identify the network path the
particular alarmed channel is traversing.
...................................................................................................................................................................................................
4
Determine if there is a NE where an OCHCOLLISION-OUT condition is present.
CLI alm
show condition
WEBUI Reports > Alarm List > Total
Reports
> Condition List
...................................................................................................................................................................................................
5
Resolve the OCHCOLLISION-OUT alarm if present by following the steps in the
procedure, “OCHCOLLISION-OUT” (p. 2-211). If this does not correct the problem,
warm
reset the alarmed card.
CLI show condition
config card
card_type shelf slot reset warm
WEBUI Select Reports > Condition List.
Select the card, click the
Reboot tab, select Cold Reboot >Submit.
...................................................................................................................................................................................................
6
Cold reset the alarmed card.
CLI alm
show condition
config card
card_type shelf slot reset cold
Trouble-clearing procedures
OCHCOLLISION
OCHCOLLISION (Channel collision)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-210
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011

Table of Contents

Related product manuals