Note: If services were provisioned in a previous software release across an invalid
physical topology (for example, no ingress amplifier in an auto-power managed
CWR8 NE), these services have to be deleted before the physical topology can be
corrected.
...................................................................................................................................................................................................
3
Alternatively, you can set the ports involved to operate under manual power management,
but this is not recommended. Contact your service representative before setting any ports
to manual power management.
PWR
PWR
This section includes procedures for the following alarms:
• PWR (Power Filter 1 breaker off or voltage low)
• PWR (Power Filter 2 breaker off or voltage low)
Trouble-clearing procedures
PRCDRERR
PRCDRERR-TOPO (Power management topology invalid)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-254
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
