EasyManua.ls Logo

Alcatel-Lucent 1830 PSS-16 - Page 505

Alcatel-Lucent 1830 PSS-16
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PWR (Power Filter 1 breaker off or voltage low) PWR (Power
Filter 2 breaker off or voltage low)
Either the voltage level of the external DC supply is low or the breaker switch has been
turned off. This alarm is raised if there is no voltage going to the breaker feed or the
voltage is below the threshold (33-35V +/- 1.5V). This could be due to the breaker being
shut off, or due to a problem with the power feed to the breaker card.
Severity Minor
Service affecting? No
Applicability PF
Corrective Action
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
Check the breakers for the alarmed shelf and verify that they are ON.
...................................................................................................................................................................................................
2
Using a DC voltmeter, measure the power going to the shelf and verify that it is within
the accepted limits for proper operation (-48 to -52 volts).
If... Then...
the EC reports that a particular PF is faulted, replace the PF.
NOTE: If you do not have a redundant power
filter configuration, this step will be service
affecting.
the EC does report that a particular PF is
faulted,
continue with Step 3.
...................................................................................................................................................................................................
3
Perform a warm reset on the Equipment Controller that is raising the PWR condition.
CLI config card card type shelf slot reset warm
WEBUI Select the card, click the Reboot tab, select Warm Reboot >Submit.
Trouble-clearing procedures
PWR
PWR (Power Filter 1 breaker off or voltage low) PWR (Power
Filter 2 breaker off or voltage low)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-255

Table of Contents

Related product manuals