...................................................................................................................................................................................................
2
Determine if there is a NE where an OCHCOLLISION-OUT condition is present.
CLI alm
show condition
WEBUI Reports > Alarm List > Total
Reports
> Condition List
...................................................................................................................................................................................................
3
Resolve the OCHCOLLISION-OUT condition (if present) by following the procedure
“OCHCOLLISION-OUT” (p. 2-211).
...................................................................................................................................................................................................
4
Perform a warm reset of the card on the alarmed card.
v
...................................................................................................................................................................................................
5
Perform a cold reset of the card.
Note: Refer to Caution at the beginning of this procedure.
CLI config card card_type shelf slot reset cold
WEBUI Select the card, click the Reboot tab, select Cold Reboot >Submit.
...................................................................................................................................................................................................
6
Reseat the card. Refer to “Reseating a Card” (p. 3-19).
...................................................................................................................................................................................................
7
Replace the card. Refer to “Replacing System Components” (p. 3-20). Follow the return
and repair process in the Customer and Product Support guide to return the faulty card to
an authorized repair center for replacement.
VCGLOA
VCGLOA (Loss of alignment)
Trouble-clearing procedures
USOCHCOLLISION
USOCHCOLLISION (Upstream Channel Collision Input
Direction)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-346
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
