...................................................................................................................................................................................................
5
The EC Protection Software Settings window is displayed. Note the Protection Setting
field.
...................................................................................................................................................................................................
6
To switch the Equipment Controller, select Enable Protection Switch.
...................................................................................................................................................................................................
7
Click Submit.
...................................................................................................................................................................................................
8
Remove any cables that are attached to the Equipment Controller to be removed.
...................................................................................................................................................................................................
9
Remove the Equipment Controller from the slot.
...................................................................................................................................................................................................
10
Select the slot for the Equipment Controller in the Equipment Tree that you removed.
...................................................................................................................................................................................................
11
Click the Delete tab.
Result: The Delete Card window is displayed.
...................................................................................................................................................................................................
12
Select the Delete this Card field, and click Submit.
...................................................................................................................................................................................................
13
Insert an Equipment Controller blank into the empty Equipment Controller slot.
Changing an NE From a Redundant to a Nonredundant Equipment Controller Configuration Using
the CLI
...................................................................................................................................................................................................
1
To backup the NE's database, see “Backing Up a Database” (p. 3-13).
...................................................................................................................................................................................................
2
If... Then...
the Equipment Controller to be removed is
active (the Active LED is green)
continue with Step 3.
the
Equipment Controller to be removed is not
active (the Active LED is not lit)
proceed to Step 4.
Supporting procedures
Changing the Equipment Controller Configuration in an NE
Changing an NE From a Redundant to a Nonredundant
Equipment Controller Configuration
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
3-75
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
