The port used by PC for synchronization: if default
port cannot be used on the PC you can change it.
If you modify the port used by the application, you
have to do the same modification on the phone
side.
Secured connection: while communicating between
Contact-Sync and the device, both unsecured HTTP
or secured HTTPS protocols can be used. If you
checked the “Use secured connection“ checkbox,
HTTPS protocol is enabled. However, to manage
this checkbox you should make sure the same
secured protocol is set up in the device. Please
contact your system administrator to find out which
protocol is used in your device.
URL for downloading the application updates.
Startup: if enabled, the application will be run
when Windows starts
Besides Settings item, there are a few item that allow you to display the last synchronization
summary, to create or delete a pairing between your phone and your PC, to open the application
online help, to display information on the application version or to exit the application.
Configuring the phone
Settings
Application Synchronization
PC address
Enter the IP address or the complete network name on which the synchronization application is
installed.
PC port
This data defines the port used on the PC for synchronization. The port must be the same as the
one filled in the PC application.
Warning when exceed
Choose if you wish to be informed when a maximum number of items for synchronization is
reached (the default setting is 500 items but this may have been changed by the administrator -
ask your administrator for the maximum number of contacts).
If you see this warning during synchronization you may lose some of your items because they have
not been synchronized.
Sync. button
Choose to display the synchronization button in the applications bar of your My IC Phone.
Back to homepage.
If you try to start the synchronization before configuring it, you will access the Synchronization
settings.
To Next Page
Loading...
