Log Settings
Log Level
The Log Level is to be used on the advice of Algo technical support only.
Log Method
Allows the 8301 to write to external Syslog server if the option for external (or both) is selected.
Log Server
If ‘Network’ or ‘Both’ is selected this is the address of the Syslog server on the network.
Management
Web Interface Protocol
HTTPS is always enabled on the device. Use ‘HTTPS Only’ mode to disable HTTP, then requests will be automatically
redirected to HTTPS. Also note that since the device can have any address on the local network, no security certificate
exists, and thus most browsers will provide a warning when using HTTPS.
Force Strong Password
When enabled, ensures that a secure password is provided for the device’s web interface for additional protection.
The password requirements are:
• Must contain at least 10 characters
• Must contain at least 1 uppercase character
• Must contain at least 1 digit (0 – 9)
• Must contain at least 1 special character
Allow Secure SIP Password
Allows SIP passwords to be stored in the configuration file in an encrypted format, to prevent viewing and recovery.
Once enabled, the SIP ‘Realm’ field should be entered and all the configured Authentication Password(s) must be re-
entered in Basic Settings → SIP, and any other locations where SIP extensions have been configured, to save the
encrypted password(s).
If the Realm is changed at a later time, all the passwords will also need to be re-entered again to save the passwords
with the new encryption.
To obtain your SIP Realm information, contact your SIP Server administrator (or check the SIP log file for a registration
attempt). The Realms may be the same or different for all the extensions used.
To Next Page
Loading...
