44 Electronic Lock Cylinders of the PegaSys Series
2.3.3 Permanently open mode
Please note: For this function, a credential with the function "permanently open" is required. The door also
has to be configured for allowing the permanently open status.
Hold your credential in front of the electronic knob until a visual signal shows that the lock cylinder has
been permanently released and can be actuated.
Or
Warning: The lock cylinder is now permanently coupled, and the door can be opened and closed without a
credential.
To cancel the permanently open function, repeat the process.
2.3.4 Special signals
Function Acoustic signal Visual signal
Idle mode - -
Start of programming mode -
End of programming mode (red)
Read mode (after waking) - (flashing red)
Coupling error
Legend
: Longer and deeper beep
: Shorter and higher beep
: LED lights up
: LED is flashing
See also
Battery exchange .................................................................................................................... 45
Short-time release .................................................................................................................. 43
Permanently open mode ......................................................................................................... 43
Visual and audible signals ...................................................................................................... 64
To Next Page
Loading...
Need help?
General
