3.4.4 Configuring the locker lock
Immediately after inserting the battery: Hold the facility or master card (depending on the product) in
front of the reader pictogram until the locker lock acknowledges the reading procedure with a visual
signal.
The rest of the procedure depends on whether the locker lock is integrated into an access control system.
For information on configuring the PegaSys Offline components in combination with an access
control system, refer to the associated documentation of the access control systems.
See also
»Teach in« (P 100) operating mode ....................................................................................... 61
Visual and audible signals ...................................................................................................... 64
3.5 Opening and closing the locker lock
Hold the credential in front of the reader pictogram [2].
Check the colored indicator [3].
Green means that the locking lever has been released and can be turned.
Red means that the credential is not authorized for releasing/locking the lock. The locking lever stays
locked.
As soon as the colored indicator [3] lights up in green:
Immediately turn the locking lever [1] by 90°.
Open or close the locker door.
Note: After locking lever [1] has been turned, it is locked again. If you want to turn the locking lever [1] again,
you have to repeat the described procedure.
See also
Visual and audible signals ...................................................................................................... 64
3.6 Battery change
Follow the same procedure as for the initial operation of the product.
See also
Inserting the battery ................................................................................................................ 53
To Next Page
Loading...
Need help?
General
