To Next Page

To Previous Page

PegaSys Locker Locks 55

3.6.1 Low battery warning levels

When a booking is performed with a credential, the PegaSys Offline signals that the charging status of the

battery has dropped below a certain level (3-stage signaling.) Thus you are informed well in time that the

battery has to be exchanged soon.

We recommend a battery change after the second level warning.

If the battery is empty, LED signals and bookings are no longer possible.

First level:

+ (...)

§ Red LED (approx. 1 second)

and booking flag (only with service flag).

Second level:

+ (...)

§ Red LED (approx. 2 seconds) with signal tone

and booking flag.

Third level:

+ (...)

§ Red LED (approx. 3 seconds)

and booking flag

After the battery change or at the initial startup, the "positive" battery status is loaded (from data format 2.1)

and written to five different credentials.

If the battery is weak, the battery status is also written to credentials five times. If the PegaSys Offline

component is connected to an access control system, this system can respond to these messages.

3.7 Resetting the locker lock

If there are malfunctions in the electronic system or if you want to re-initialize the product completely, you

have to perform a reset.

To do so, you need the facility or master card (depending on the mode of operation.)

Proceed as follows:

Remove the battery (as described under "Initial operation".)

Wait a short while.

Insert the battery again, and immediately thereafter hold the facility/master card in the read area, until

the product acknowledges the reading procedure with a visual signal (red signal followed by two green

flashes).

Depending on the product and operating mode, other data has to be downloaded.

Ensure correct polarity!

When inserting the battery, observe the correct polarity. An incorrectly inserted battery

can damage the device.

Allegion PegaSys User Manual

Questions and Answers: