Allen-Bradley 825-P - Required Equipment; Equipment Shipping with the Card; User-Supplied Equipment; Wiring

To Next Page

To Previous Page

116 Rockwell Automation Publication 825-UM004D-EN-P - November 2012

Chapter 9 825-PDN DeviceNet Communication Card

Required Equipment

Equipment Shipping with the Card

When you unpack the card, verify that the package includes:

• One DeviceNet communication card

• One five-pin linear DeviceNet plug

• Two labels that the installer affixes to the 825-P Modular Protection

stem, one to the top and one to the back panel

• 825-P Option Card installation instructions

User-Supplied Equipment

• Small slotted screwdriver (0.6 x 3.5 mm)

• DeviceNet cable, a thin cable with outside diameter of 6.9 mm (0.27 in.),

is r

ecommended

• Configuration tool (e.g., RSNetWorx for DeviceNet)

• Computer with an installed DeviceNet communication adapter

• 825-P User Manual

Wiring

1. Remove power from the DeviceNet network and 825-P Modular

Protection System relay

2. Use static control precautions

3. Connect a DeviceNet cable to the network

4. Terminate the bare leads of the DeviceNet cable to the 5-pin linear plug

as i

llustrated in Figure 40