166 Rockwell Automation Publication 825-UM004D-EN-P - November 2012
Chapter 12 ASCII Serial Communications
Access Level 2, the relay sends the =>>prompt at which you press Enter or after
a command response is finished.
Command Summary
Table 99 lists the serial port commands associated with particular activities. The
commands are shown in upper-case letters, but they can also be entered with
lower-case letters.
The serial port command explanations that follow in the Description of
Commands subsection are in alphabetical order to correspond with Table 99.
Table 99 - 825-P Serial Port Command Summary
Serial Port
Command
Access
Level
Command Description
Page
Number
2ACCESS 1, 2 Go to Access Level 2.
Page 167
ACCESS 0, 2 Go to Access Level 1.
Page 167
ANALOG 2 Test analog output.
Page 167
DATE 1, 2 View or Change date.
Page 167
METER 1, 2 Display metering data.
Page 168
MOTOR 1, 2 Display motor operating statistics report.
Page 170
MOTOR R or C 2 Reset motor operating statistics.
Page 170
PASSWORD 2 View or Change password.
Page 170
QUIT 1, 2 Go to Access Level 0.
Page 171
SER 1, 2 View serialized events recording data.
Page 171
SER R or C 1, 2 Reset serialized events recording data.
Page 171
SET 2 Enter or Change relay settings.
Page 172
SHOW 1, 2 Show/view relay settings.
Page 173
STATUS 1, 2 Display relay self-test status.
Page 174
STATUS R or C 2 Clear self-test status and restart relay.
Page 177
STOP 2 Stop motor.
Page 177
STR 2 Start motor.
Page 177
SUMMARY 1, 2 View event summary reports.
Page 177
SUMMARY R or C 1, 2 Reset event summary buffer.
Page 178
TARGET 1, 2 Display relay elements, inputs or outputs status.
Page 178
TARGET R 2 Reset trip/target LEDs.
Page 179
TIME 1, 2 View or Change time.
Page 179
To Next Page
Loading...