UniLinc Identification
Operational Keypad
The control includes seven keypads. These functions are availa-
ble to the operator and are intended to control and manage opera-
tion of the tumble dryer. Refer to Figur
e 5 and Table 1 .
Figure 5
Keypad Description
LCD/UP ARROW Press to move the cursor on display and to edit programming values. Also, press while
in Cycle Menu or Run Menu to change to the Contrast Adjust/Backlight Menu. Also,
press with and to enter System Menu.
DOWN ARROW Press to move the cursor on display and edit programming values.
LEFT ARROW Press to move the cursor on display.
BACK
Press to move back to the previous display menu. Also, press with and to
enter System Menu.
RIGHT ARROW Press to move the cursor on display. Press while running a cycle to get to Run Diag-
nostic Menu.
STOP/ON/OFF
Press to stop and abort a machine cycle during Run Mode. Also press with and
to enter System Menu. When in Cycle Programming Menu, press to turn seg-
ments and cycles on and of
f.
ST
ART/ENTER
Press to start or rapid advance a machine cycle during Run Mode. Also, press to save
edited programming values when used in programming menus.
Table 1
Operation Modes
General Modes of Operation
In each mode of operation, the user may press keypads or com-
municate with the control to change the displayed menu.
Power-up Mode
The control enters this mode at power-up. After the control com-
pletes operation in the Power
-up Mode it will enter Idle Mode.
The display is blank during Power
-up Mode.
Idle Mode
The control is ready for operation in Idle Mode. Control can dis-
play dif
ferent menus depending on user input (keypad press,
opening or closing the loading door
, or PDA communication). If
UniLinc Identification
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
10
To Next Page
Loading...
