7
List of Figures
Figure 1: Full Populated MMCR18 Chassis with Rack-mount Brackets Attached................................................................14
Figure 2: MMCR18 Front Panel............................................................................................................................................14
Figure 3: Back Panels ..........................................................................................................................................................15
Figure 4: MMCR18FAN Unit.................................................................................................................................................16
Figure 5: LEDs on the Front Panel .......................................................................................................................................17
Figure 6: Example of Alarm Out Usage on the Fan Unit ......................................................................................................18
Figure 7: Back Panel ............................................................................................................................................................31
Figure 8: Inserting the AC Power Supply Unit into Slot A.....................................................................................................31
Figure 9: Inserting the DC Power Supply Unit into Slot A.....................................................................................................31
Figure 10: Combinations of Two Power Supply Units ..........................................................................................................32
Figure 11: Front Panel with the Cover Panel........................................................................................................................33
Figure 12: Removing the Cover Panel..................................................................................................................................33
Figure 13: Attaching the Rack-Mount Brackets ....................................................................................................................34
Figure 14: Installing the Chassis in a Rack...........................................................................................................................35
Figure 15: Attaching the Sliding Carrier on a Media Converter ............................................................................................36
Figure 16: Media Converter on the Sliding Carrier ...............................................................................................................36
Figure 17: Installing the Media Converter in the Chassis .....................................................................................................37
Figure 18: Tightening the Captive Screw on the Sliding Carrier...........................................................................................37
Figure 19: Installing the Blank Panel to Cover an Empty Slot ..............................................................................................38
Figure 20: Locating the Terminals on the DC Terminal Block ..............................................................................................40
Figure 21: Stripped Wire.......................................................................................................................................................41
Figure 22: Connecting the Frame Ground Wire....................................................................................................................42